In order for these printers (in Trade Central) to work on Windows 10 they need to be in Manual Configuration Mode.

They should already be set in Manual Configuration, but just in case they are not.

How to get the iTherm 280 Printers in Manual Mode

Manual Configuration

This mode allows manual configuration of the printer.

To enter manual configuration mode:

1. Power the printer off.

2. Hold the Feed button.

3. Power printer on, while still holding the Feed button.

4. Release the Feed button when you see the fast blink red LED light.

5. Printer is now in Test Mode, ready to run the first test, i.e. Operation – Receipt Print

6. Press and hold the Feed button until it prints Operation – Electronic Journal, then release the Feed button.

7. Press and hold the Feed button until it prints Operation – Configuration, then release the Feed button.

8. Press and release the Feed button.

9. The printer will print the software revision information and instructions for using this mode.

To navigate the Configuration Mode:

1. Press and release Feed Button (Short Press) to run go to the next item.

Make sure that the system is set to USB Mode Only.

2. Press and hold the Feed Button (Long Press) to change the item’s option.

Once all changes are made you must save the configuration.

To save the configuration:

1. Press and release the Power button. Printer will print the revised configuration.

2. Press and release the Feed Button (Short Press) to save the configuration.

3. Printer will reset to a ready state.